If your Auto button is grayed out, it most likely means that a Target
Tension has been set. To check your Target tension, click Options,
then Target Tension.
Open Your Belt Analyst directory. Find the Templates folder and delete
it. This will reset the templates so that they are all available in
Belt Analyst.
The Ports used are standard http/https
The current address is 66.150.99.98. PLEASE NOTE THAT THIS CAN MOVE
WITHOUT NOTICE.
license.overlandconveyor.com [http://license.overlandconveyor.com/] is
a CNAME for solo.overlandconveyor.softwarekey.com
[http:/...
If you no longer have access to the computer the license is activated
on or your computer has crashed, you can now deactivate the license
remotely, without having to call OCC. To deactivate the license,
follow these instructions.
1. Log in to your licen...
Follow the instructions below to "Silent Install" the program:
* Generate a response file. The easiest way of doing that is as
follows:
* Open command line and navigate to the setup.exe location.
* Once there, run the following "Statix.exe" -r -f...