Knowledgebase: 2D / 3D Profile View
2D and 3D view
Posted by Tawna Kjera on 19 April 2011 06:58 PM
Right click on the profile in Belt Analyst. Select the “Show 2D profile view” to view the conveyor profile. A new window will pop up showing the tail end of the conveyor. You can jump to different areas of the conveyor by double clicking any of the regions on the right panel. There are (+) and (-) buttons in the top left corner that can be used to zoom in and out of the profile. You can switch to the 3D profile by going to File ->Switch to 3D.

Comments (0)